Audi Q5: Center armrest
The armrest is adjustable in several stages and
can be moved forward and back.
Fig. 71 Armrest between driver's and passenger's seat
Adjusting the armrest
- To adjust the armrest angle, pivot the armrest
fully down.
- Lift the armrest detent by detent until the desired
position is reached.
Moving the armrest
- You can move the armrest forward or back
> fig. 71.
There is a storage compartment under the armrest.
READ NEXT:
Expanding the passenger compartment
The rear seat backrests can be folded forward
separately or together.
Fig. 72 Release lever for the outer backrest
Fig. 73 Release button for the center backrest
The rear seat backrests can be folded forward
separately or together.
Fig. 74 Luggage compartment: release lever
Folding the backrest forward
Pull the release lever > fig. 74 in direction of
th
There are four tie-down rings in the luggage
compartment for securing luggage items.
Fig. 75 Location of the tie-down rings in the luggage compartment
Secure the cargo to the tie-down rings
> f
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Piston Resetting Tool -T10145-
Note
If old brake pads are being replaced with new ones, then it is necessary to
check the brake rotor for wear. Pay attention to the brake rotor wear limit
while doing thi
Note
For repairing a 0.222 a repair
wire can be used as the intermediate wire with a cross section
of 0.35-mm2 or 0.5-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the electrical
