Audi Q5: Inflating inflatable spare tire
Applies to vehicles: with inflatable spare tire
.jpg)
Fig. 213 Luggage compartment left side: compressor
- Remove the left trim panel in the luggage compartment.
- Open the Velcro strap and remove the compressor
> fig. 213.
- Unscrew the valve stem from the spare tire.
- Screw the tire filler hose from the compressor
firmly onto the valve of the spare tire.
- Insert the plug from the compressor into a
socket of the vehicle.
- Switch the compressor on.
- Let the compressor run until the value specified
on the tire pressure label is reached
> fig. 207. Switch the compressor
off after running for 12 minutes at the most -
danger of overheating!
WARNING
The compressor and the tire filler hose can
become extremely hot while they are running
- danger of burns!
Note
Switch the compressor off after running for
12 minutes at the most - danger of overheating!
Allow the compressor to cool down for a
few minutes before you use it again.
READ NEXT:
General information and safety precautions
Applies to vehicles: with tire repair kit
The tire repair is only meant for temporary use.
Fig. 214 Tire damage, for which the tire repair kit is not
suitab
Applies to vehicles: with tire repair kit
Fig. 215 Performing the repair
Preparations
Park the vehicle as far as possible from moving
traffic in the event of a flat tire.
Set the parking brake to
Before changing a wheel
Observe the following precautions for your own
and your passenger's safety when changing a
wheel.
After you experience a tire failure, pull the car
well away from moving tra
SEE MORE:
The starting assist function ensures that the parking brake is released
automatically upon starting.
Stopping and applying parking brake
Pull the switch to apply the parking brake.
Starting and automatically releasing the parking brake
When you start to drive as usual, the parking brake is aut
Note
Adjust the front glass sunroof panel only on the front edge
and the rear glass sunroof panel on the rear edge.
To achieve the best possible exterior optical
characteristics, make sure that the adjustment on left and right
sides is performed as evenly (symmetrically) as possible.