Audi Q5: Settings in the radio/MMI
Applies to vehicles: with Audi adaptive cruise control
- Select:
function button > Audi braking
guard. Or
- Select:
function button > Car systems
control button > Driver assist > Audi braking
guard.
System - Switch braking guard On and Off. When
you switch the ignition on, the message Braking
guard: Off appears if the system is switched off.
Early warning - The distance and approach warnings
in the display can be switched On/Off.
Tips
- Your settings are automatically stored and
assigned to the remote control key being
used at the times the settings are made.
- If you restrict the ESC, the braking guard also
switches itself off.
- Switch braking guard off when you are loading
the vehicle onto a vehicle carrier, train,
ship or other type of transportation. This
can prevent undesired warnings from the
braking guard system.
READ NEXT:
Applies to vehicles: with Audi adaptive cruise control
Braking guard: Off
This driver message appears if the system is
turned off via the radio/MMI. Otherwise, if the
system is turned off, the informa
Applies to vehicles: with Audi side assist
Fig. 127 Sensor detection range
Fig. 128 Display on the exterior mirror
Side assist helps you monitor your blind spot and
traffic behind your vehicle. With
SEE MORE:
Applies to vehicles: with Start-Stop-System
Fig. 104 Instrument duster: Engine switched off (stop
phase)
Slow the vehicle to a stop using the brake and
keep pressing the brake pedal. The engine will
switch off. The
indicator light appears in the
instrument cluster display and
also
appears
Note
For the repair use repair wires with a cross section of 0.35
mm2 through 6.0-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harness