Audi Q5 Owners & Service Manuals

Audi Q5: Changing brake fluid

Have the brake fluid changed by an experienced technician.

Brake fluid absorbs moisture from the air. If the water content in the brake fluid is too high, corrosion in the brake system may result after a period of time. The boiling point of the brake fluid will also decrease considerably and decrease braking performance.

Therefore, the brake fluid must be changed every two years. Always use new brake fluid which conforms to Federal Motor Vehicle Standard "FMVSS 116 DOT 4".

The brake fluid reservoir can be difficult to reach, therefore, we recommend that you have the brake fluid changed by your authorized Audi dealer. Your dealer has the correct tools, the right brake fluid and the know-how to do this for you.

WARNING

  • Brake fluid is poisonous. It must be stored only in the closed original container out of the reach of children!
  • Brake failure can result from old or inappropriate brake fluid. Observe these precautions:
    • Use only brake fluid that meets SAE specification J 1703 and conforms to Federal Motor Vehicle Standard 116. Always check with your authorized Audi dealer to make sure you are using the correct brake fluid.

      The correct type of brake fluid is also indicated on the brake fluid reservoir.

    • The brake fluid must be new. Heavy use of the brakes can cause a vapor lock if the brake fluid is left in the system too long.

      This can seriously affect the efficiency of the brakes as well as your safety. This could result in an accident.

Note

Brake fluid will damage the paint of your vehicle.

For the sake of the environment

Because of the problem of proper disposal of brake fluid as well as the special tools required and the necessary expertise, we recommend that you have the brake fluid changed by your authorized Audi dealer.

    READ NEXT:

     Battery

    General information Under normal operating conditions, the battery in your Audi does not need any maintenance. With high outside temperatures or long daily drives we recommend that you have the elect

     Working on the battery

    Be especially careful when working on or near the battery. The battery is located in the luggage compartment under the floor. Before you check anything in the luggage compartment, read and heed all W

     Battery charging

    Starting the engine requires a well charged battery. Fig. 202 Engine compartment: Connectors for charger and jumper cables Always read and heed all WARNINGS below. Hybrid drive: read the important

    SEE MORE:

     Window Frame Trim, Removing and Installing

    Special tools and workshop equipment required Trim Removal Wedge -3409- Removing - Lower the door window. - Remove the rear door trim panel. Refer to → Chapter "Rear Door Trim Panel, Removing and Installing". - Versions with a sun shade: Remove the sunshade mounts → 

     Fiber-Optic Cable, Preparing with the Fiber-Optic Conductor Repair Set -VAS6223A-

    Special tools and workshop equipment required Fiber-Optic Conductor Repair Set -VAS6223A- Hose Cutting Pliers -VAS6228- Vehicle Diagnostic Tester   Caution Do not bend the fiber-optic cable too much. The bending radius must be no less than 25 mm. Fiber optic cables must not be routed o

    © 2019-2025 Copyright www.audiq5.net