Audi Q5: Checking and Filling
READ NEXT:
Releasing the engine hood
The engine hood is released from inside the vehicle.
Fig. 195 Driver's side footwell: engine hood release lever
With the driver's door open, pull the lever under
the inst
Pull the hood down until the pressure from the
struts is reduced.
Let the hood drop down and latch in place. Do
not try to push it shut; it may fail to engage.
WARNING
A hood that is not complet
Engine compartment
These are the most important items that you can check.
Fig. 197 Typical layout for containers and engine oil filler cap
Jump start point (+) under a cover
Brake fluid reservoir
SEE MORE:
1 - Bolt
70 Nm +180º
Always replace if removed
Must be tightened in the curb weight position. Refer to
→ Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil
Spring".
2 - Bracket
3 - Left Rear Level Control System Sensor -G76-
Only sensors
Malfunction Indicator Lamp (MIL)
The Malfunction Indicator Lamp (MIL)
in the instrument cluster > fig. 8
is part of the On-Board Diagnostic (OBD II) system.
The warning/indicator light illuminates when the ignition is switched on and
goes out after the engine starts and the idle has stabilize