Audi Q5: Interior Equipment
READ NEXT:
1 - Center Console
Overview. Refer to
→ Chapter "Overview - Center Console".
2 - Driver Side Instrument Panel Cover
Overview. Refer to
→ Chapter "Overview - D
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Removing
- Switch off all electrical consumers.
- Remove ignition key.
- Remove the side cover from the instr
Special tools and workshop equipment
required
Locking Pin (3 pc.) -T40011-
Removing
- Insert the Locking Pin -T40011- through an opening
-arrow- on the side of the glove
compartment lid and
SEE MORE:
Navigation Connector Assignment
Information Electronics Control Module 1 -J794-
1 - Not Assigned
2 - Connection block with four multipin connectors
3 - MOST Bus
4 - CVBS input
5 - 4-pin connector (T4al/T4am) for the Front Information
Display Control
Overview - Bulkhead
1 - Seal
Install the seal from underneath.
2 - Lock Washer
When installing, simply press the plenum chamber bulkhead onto the
threaded pins.
3 - Nut
4 Nm
4 - Bolt
7 Nm
5 - Plenum Chamber Bulkhead
High-Voltage System
