Audi Q5: Body Interior
READ NEXT:
Pay attention to the following when working on a vehicle
with Stop/Start system:
WARNING
There is a risk of injury if the engine starts
automatically in vehicles with the Start/Stop System.
Caution
After each repair to the front passenger seat where
the seat or backrest cover was
"removed", a basic setting of the passenger
occupant detection system control module must be
p
SEE MORE:
Tie Rod End, Removing and Installing, Electromechanical Steering Gear
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Torque Wrench 1332 Insert - Ring Wrench - 21mm -VAG1332/7-
Puller - Ball Joint -T40010A-
Removing
-&nbs
- Do not run engine and turn front wheels to straight ahead
position.
Fluid cold (approximately 20 ºC (68 ºF) ):
- Remove the cap.
- Wipe dipstick off with a clean cloth.
- Screw cap on hand-tight and unscrew again.
Note
The cap must be fully screwed in order to obtain
Start/Stop System Safety Precautions
