Audi Q5: General, Technical data
READ NEXT:
Pay attention to the following when working on a vehicle
with Stop/Start system:
WARNING
There is a risk of injury if the engine starts
automatically in vehicles with the Start/Stop System.
Caution
After each repair to the front passenger seat where
the seat or backrest cover was
"removed", a basic setting of the passenger
occupant detection system control module must be
p
WARNING
After every accident the seat belt system must be
inspected systematically! If damage is determined when
inspecting the check points, customer must be informed
regarding necessity
SEE MORE:
Overview - Drive Axle with 89 mm Outer CV Joint and 100 mm Inner CV
Joint
1 - Bolt
200 Nm +180º
Always replace if removed
Follow the assembly information when loosening and tightening. Refer
to
→ Chapter "Drive Axle Threaded Connection, Loosening and Tightening".
2 -&
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set - Adapter 40 - VW771/40- from the Slide
Hammer Set - VW771-
Retainer - Drive Flange - 3028-
Puller - Unit Injector -T10055-
-2-Puller - Unit Injector -
Adapter 2 -T10055/2-
Seal Installer - Drivesh
Start/Stop System Safety Precautions
