Audi Q5 Owners & Service Manuals

Audi Q5: Switches and Sensors on Refrigerant Circuit and Connections

READ NEXT:

 A/C Refrigerant High Pressure Switch -F23-

  Note Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit → Heating, Ventilation and Air Condit

 A/C Pressure Switch -F129-

  Note Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit → Heating, Ventilation and Air Condit

 A/C Compressor Regulator Valve -N280-

  Note Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit → Heating, Ventilation and Air Condit

SEE MORE:

 Repairing a Wire 0.35 mm 2 or Greater with Individual Crimp Connector

Procedure - Free up the wire to be repaired approximately 20 cm on both sides of the repair point.   Caution Risk of damaging the electrical wires. Expose wrapped wiring harnesses carefully. - If necessary, removing the wiring harness wrapping using a knife. - Cut out the dam

 Test Sequence

Battery, Checking, Vehicles with Battery Monitoring Control Module J367 or Energy Management Control Module J644 and Data Bus On Board Diagnostic Interface J533 In certain model series the following is responsible for monitoring the electrical system: Energy Management Control Module -J644- or

© 2019-2025 Copyright www.audiq5.net