Audi Q5 Owners & Service Manuals

Audi Q5: Uniform tire quality grading

  • Tread wear
  • Traction AA А В C
  • Temperature ABC

Quality grades can be found where applicable on the tire side wall between tread shoulder and maximum section width > fig. 204.

For example: Tread wear 200, Traction AA, Temperature A.

All passenger car tires must conform to Federal Safety Requirements in addition to these grades.

Tread wear

The tread wear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified government test course.

For example, a tire graded 150 would wear one and one half (1 1/2) times as well on the government course as a tire graded 100.

The relative performance of tires depends upon the actual conditions of their use, however, and may depart significantly from the norm due to variations in driving habits, service practices and differences in road characteristics and climate.

Traction

The traction grades, from highest to lowest, are AA, A, В and C. Those grades represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performance.

Temperature

The temperature grades are A (the highest), B, and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel.

Sustained high temperature can cause the material of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure.

The grade C corresponds to a level of performance which all passenger car tires must meet under the Federal Motor Vehicle Safety Standard No. 109. Grades В and A represent higher levels of performance on the laboratory test wheel than the minimum required by law.

WARNING

The traction grade assigned to this tire is based on straight-ahead braking traction tests, and does not include acceleration, cornering, hydroplaning or peak traction characteristics,

WARNING

The temperature grade for this tire is established for a tire that is properly inflated and not overloaded Excessive speed, underinflation, or excessive loading, either separately or in combination, can cause heat buildup and possible tire failure.

WARNING

Temperature grades apply to tires that are properly inflated and not over or underinftated.

    READ NEXT:

     Tire pressure monitoring system

    General notes Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard

     Troubleshooting

     Emergency assistance

    SEE MORE:

     Vacuum System, Checking

    Tests and Test Requirements Special tools and workshop equipment required Brake Servo Tester -VAS6721- The following checks will be helpful when performing Fault Finding if there are complaints regarding the brake booster or the so-called "hard brake pedal". The following components are includ

     Closing the engine hood

    Pull the hood down until the pressure from the struts is reduced. Let the hood drop down and latch in place. Do not try to push it shut; it may fail to engage. WARNING A hood that is not completely latched could fly up and block your view while driving. When you close the engine hood, check

    © 2019-2026 Copyright www.audiq5.net