Audi Q5 Owners & Service Manuals

Audi Q5: Driver messages

Audi Q5 Type 8R (2008 - 2017) Owner's Manual / Operation / Audi side assist / Driver messages

Applies to vehicles: with Audi side assist

If side assist switches off by itself, the LED in the button turns off and a message will appear in the instrument cluster display:

Audi side assist unavailable: Sensors blocked

The radar sensors' vision is affected. Do not cover the area in front of the sensors with bike wheels, stickers, dirt or other objects. Clean the area in front of the sensors, if necessary > fig. 130.

Audi side assist: Currently unavailable

Side assist cannot be switched on temporarily because there is a malfunction (for example, the battery charge level may be too low).

Audi side assist: System fault!

The system cannot guarantee that it will detect vehicles correctly and it is switched off. The sensors have been displaced or are faulty. Have the system checked by an authorized Audi dealer or authorized Audi Service Facility soon.

Audi side assist: Unavailable when towing

Side assist switches off automatically when a factory- installed trailer hitch is connected to the electrical connector on the trailer. There is no guarantee the system will switch off when using a retrofitted trailer hitch. Do not use side assist when towing a trailer.

    READ NEXT:

     Audi drive select

     Introduction

    Applies to vehicles: with Audi drive select Drive select provides the possibility to experience different types of vehicle settings in one vehicle. For instance, using the three Comfort, Auto and Dyn

     Selecting the driving mode

    Applies to vehicles: with Audi drive select You can choose between Comfort, Auto, Dynamic and Individual modes, Fig. 132 Center console: Control for drive select Fig. 133 MMI: Audi drive select To

    SEE MORE:

     Bluetooth Car Phone Connector Assignment

    Information Electronics Control Module 1 -J794- 1 - Antenna Connection (GSM) from the Roof Antenna -R216- 2 - Connection block with four multipin connectors 3 - MOST Bus 4 - Not Assigned 5 - 4-pin connector (T4am) for the Front Information Display C

     Door Lock Cable, Removing and Installing

      Caution There is a risk of malfunctions. The door lock must be removed and installed together with the bracket to prevent overbending the cable when disengaging and engaging it. The cable must be disconnected from/attached to the lever on the door lock outside of the door. Removing -&nbs

    © 2019-2025 Copyright www.audiq5.net