Audi Q5: Infotainment System
READ NEXT:
Overview - Infotainment System
The MMI Infotainment system is available in the following
equipment levels:
MMI maximum equipment
The Information Electronics Control Module 1 -J794- inside
the inst
The Front Information Display Control Head -J685- (Display)
is located in the center of the instrument panel.
- Turn off the ignition and all electrical consumers and
remove the ignition key.
Information Electronics Control Module 1 -J794-
1 - Not Assigned
2 - Connection block with four multipin connectors
3 - MOST Bus
4 - Not Assigned
5 -
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Torque Wrench 80-400Nm -VAG1576-
Removing
- Remove drive axle. Refer to
→ Chapter "Drive Axle, Removing and Installing".
- Insert both of upper control arm
Adaptive Cruise Control (ACC), Calibrating, Calibration Procedure with
Setting Device Basic Set -VAS6430/1-
Special tools and workshop equipment
required
Vehicle Diagnostic Tester
Vehicle Diagnosis System - Updated Cable - 3m -VAS5051/5A-
Setting Device Basic Set -VAS6430/1-
Wheel Alignment C