Audi Q5 Owners & Service Manuals

Audi Q5: Luggage compartment cover

Audi Q5 Type 8R (2008 - 2017) Owner's Manual / Operation / Seats and storage / Luggage compartment cover

Seats and storage
Fig. 76 Luggage compartment: cover attached

Seats and storage
Fig. 77 Luggage compartment: storing the cover

Removing

  • Unhook the straps 1 > fig. 76.
  • Pull the cover 3 out of the retainers 2 in the direction of the arrow.

Installing

  • Slide the cover into the retainers 2.
  • Attach the straps 1.

Storing

  • Slide the rear seat forward.
  • Fold the cover together and store it behind the rear seat > fig. 77.

WARNING

  • To prevent accidents, never install the luggage compartment cover unsecured.
  • Whenever driving, never place any hard or heavy objects on the luggage compartment or allow pets to sit on the luggage compartment cover. They could become a hazard to vehicle occupants in the event of sudden braking or in an accident.

Note

You could damaged a stored luggage compartment cover when you move the rear seat or rear seat backrest.

Tips

  • You can use the luggage compartment cover to store light weight clothing or articles but do not leave any heavy or sharp objects in the pockets of the clothing.
  • Remember that placing clothing or articles on the luggage compartment cover can block the driver's vision in the rear view mirror.

    This also applies especially when you have to transport large objects.

  • So that stale air can escape from the vehicle be sure not to cover the ventilation slot between the rear lid and the luggage compartment cover.

    READ NEXT:

     Double cargo floor

    You can store dirty or wet objects under the cargo floor. Fig. 78 Luggage compartment: cargo floor folded together with protective tray Folding the cargo floor together Lift the cargo floor by the

     Roof rack

    Description Additional cargo can be carried with a roof luggage rack. If luggage or cargo is to be carried on the roof, you must observe the following: Only a specially designed roof rack may be use

     Installing a roof rack

    Fig. 82 Roof railing: positioning the roof rack Fig. 83 Roof railing: installing a roof rack The roof rack set consists of a front and rear roof rack, the cover profile and a socket wrench. Open t

    SEE MORE:

     Overview - Subframe

    1 - Bolt 70 Nm +180º Always replace if removed Must be tightened in the curb weight position. Refer to → Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring". 2 - Bracket 3 - Left Rear Level Control System Sensor -G76- Only sensors

     Technical Data

    Technical data Vehicle identification Fig. 236 Vehicle Identification Number (VlN) plate: location on driver's side dash panel Fig. 237 Vehicle identification label: inside the luggage compartment Vehicle Identification Number (VLN) The Vehicle Identification Number is located in different places

    © 2019-2026 Copyright www.audiq5.net