Audi Q5: Seals
READ NEXT:
Seals Component Location Overview, 0BC, 0BD
1 - Right Ring
Replacing. Refer to
→ Chapter "Flange Shaft Protective Ring, Replacing".
2 - Right Seal
Replacing. Refer to
Left Seal, Replacing, 0BC
In this chapter "right seal, replacing" is also described.
The shaft seal can be only be replaced with the final drive
removed.
Special tools and workshop equipment
req
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set - Adapter 40 - VW771/40- from the Slide
Hammer Set - VW771-
Retainer - Drive Flange - 3028-
Puller -
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931- with Universal Support
Plate -VAG1359/2-
Hydraulic Press -VAS6178-
Pneumatic/Hydraulic Foot Pump -VAS6179-
Bearing Installer - Wheel Hub/Bearing Kit -T10205-
Hydraulic Press
Gap Cover, Removing and Installing, Vehicles without a Retaining Track
Removing
- Remove the front luggage compartment floor. Refer to
→ Chapter "Luggage Compartment Floor, Removing and Installing,
Non-Hybrid Vehicles".
- Remove the dirt shield, if applicable.
- Remove the tie
Component Location Overview - Seals
