Audi Q5: General, Technical data
READ NEXT:
Final Drive Identification
Final Drive Identification, 0BC
The 0BC rear final drive unit is used with the following
transmissions:
6-Speed Manual Transmission 0B2 All Wheel Drive (AWD)
6-Speed Man
Transmission/Engine Allocation
Refer to the Parts Catalog for the following information.
Codes
Production time period.
Axle ratio
Drive Axle flange allocation
Allocated to the engine, manual tra
1 - Transmission
2 - Driveshaft
Overview. Refer to
→ Chapter "Overview - Driveshaft".
Removing and installing. Refer to
→ Chapter "Driveshaft, Removing and Inst
SEE MORE:
Note
If the mechanically driven Air Conditioning (A/C) compressor
was removed, rotate it approximately 10 times by hand before
using it for the first time (during or after installing, for
example before installing the belt) to prevent damage caused by
liquid impact when first switched
Electromechanical Steering Gear Tie Rod, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Torque Wrench 1332 Insert - Ring Wrench - 21mm -VAG1332/7-
Hose Clip Pliers -VAG1921-
Torque Wrench Insert - Open Jaw -VAG1923-
Clamping Pliers
Identification
