Audi Q5: Battery, Starter, Generator, Cruise Control
READ NEXT:
Battery General Information
To guarantee a long service life, the Battery -A- must be
checked, serviced and maintained as described in this manual.
The Battery -A- supplies the power to start the eng
Battery, Checking, Vehicles with Battery Monitoring Control Module J367
or Energy Management Control Module J644 and Data Bus On Board Diagnostic
Interface J533
In certain model series the followi
WARNING
Risk of injury. Follow all warning messages and
safety precautions. Refer to
→ Chapter "Warnings and Safety Precautions".
Before any extensive measurements are taken, visuall
SEE MORE:
Caution
Do not bend the fiber-optic cable too much. The
bending radius must be no less than 25 mm.
Fiber optic cables must not be routed over sharp
edges.
The fiber-optic cable must not be dirty or touched
with bare fingers.
Fiber optic cables may not be heated.
It is not permitted to tw
(The rear final drive is removed.)
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set -VW771-
Slide Hammer Set - Hook -VW771/37-
Seal Installer - Propshaft Flange - T40112-
Retainer - Drive Flange - 3028-
Seal Installer - Wheel Bearing Seal - 3143