Audi Q5: Steering
- Steering Wheel
- Overview - Steering Column
- Steering Intermediate Shaft, Removing and Installing
- Steering Column, Removing and Installing
- Steering Column, Handling and Transporting
- Electronic Steering Column Lock Control Module -J764-, Removing and
Installing
- Active Steering Safety Lock (Locking Magnet), Removing and Installing
- Overview - Steering Gear
- Steering Gear, Removing and Installing
- Steering, Centering
- Steering Gear, Servicing
- Boot, Removing and Installing
- Boot, Removing and Installing, Hydraulic Power Steering Gear
- Tie Rod, Removing and Installing
- Tie Rod, Removing and Installing, Hydraulic Power Steering Gear
- Tie Rod End, Removing and Installing
- Power Steering Fluid Level, Checking
- Hydraulic Fluid Cooler, Removing and Installing
- Special Tools
READ NEXT:
Overview - Steering Wheel
1 - Airbag Spiral Spring/Return Spring with Slip Ring -F138-
Removing and installing. Refer to
→ Electrical Equipment; Rep. Gr.94; Steering Col
1 - Bolt
Tightening specification. Refer to
→ Body Interior; Rep. Gr.70; Instrument Panel Central Tube; Overview -
Instrument Panel Central Tube.
2 - Bracket
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Removing
- Bring wheels in the straight position.
- Position the steering wheel as far down as possible
SEE MORE:
Removing
- Remove the outer cover on the rear seat backrest. Refer to
→ Chapter "Outer Cover, Removing and Installing".
- Carefully remove the backrest release handle
-2- from the rear seat.
- Lift the tab on the inside of the backrest release handle
-3- with a small screwdrive
Fig. 82 Roof railing: positioning the roof rack
Fig. 83 Roof railing: installing a roof rack
The roof rack set consists of a front and rear roof
rack, the cover profile and a socket wrench.
Open the cap 1 > fig. 83.
Before mounting the roof rack, use the socket
wrench 2 and loosen the left
